Download • Audi A6 2000, VW Jetta, Passat, Golf/GTI 2001 • Ford, Lincoln and Mercury vehicles: Navigator 1997-1998, Explorer 1995-1997, Windstar 1999- 2000, Town Car and Grand Marquis 1996-1997. Programming Do not mount the IR LED at this time. Wait until the SWI-7 is programmed and operation is verified. Programming the SWI-7 to control the new aftermarket head unit: After terminating the red, black and green wires the interface is ready to be programmed. First check that the IR remote that was supplied with the new head unit works properly. If the remote does not properly control the head unit, the interface cannot be programmed. Weak batteries in the remote my cause programming errors, even if the remote seems to operate properly. 1) Move the GM-Ford select switch on the side of the SWI-7 to the correct position depending on the make of vehicle you are working on. 2) Turn on the ignition to supply power to the SWI-7 and the steering wheel/ rear seat radio controls. 3) Use a pen to depress the “program mode” button. Remove pen when left LED light comes on. 4) Within 8 seconds press one of the steering wheel or rear seat control function buttons. Do not hold the function button, simply press and release as you would normally do when operating the factory radio. The right LED should light indicating the interface is ready to learn the IR remote control’s command. 5) Place the stereo’s IR remote within 3″ of the “IR Input” port on the side of the SWI-7 next to the program button. Press and hold the remote’s button that corresponds to the steering wheel button that was pressed. Continue to hold the remote’s button until the right LED turns off. Release the button and the left LED will turn on.
↧
